Re: Flyback Driver PCBs

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Jim Mitchell" <electrontube-at-sbcglobal-dot-net> 

The overload protection circuit will pulse the output I guess attempting to
clear a short or whatever is causing the excess current draw.  In that sense
it pulses at 2hz

Regards - Jim Mitchell
----- Original Message -----
From: "Tesla list" <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Friday, April 16, 2004 2:32 PM
Subject: Re: Flyback Driver PCBs


 > Original poster: "Dan" <pbursa-at-cfl.rr-dot-com>
 >
 > a) you have to disable overload protection circuit
 > b) what you mean 2 Hz ? of course it will not work -at- 2Hz
 > Vladan
 > ----- Original Message -----
 > From: "Tesla list" <tesla-at-pupman-dot-com>
 > To: <tesla-at-pupman-dot-com>
 > Sent: Friday, April 16, 2004 10:18 AM
 > Subject: Re: Flyback Driver PCBs
 >
 >
 >  > Original poster: "Jim Mitchell" <electrontube-at-sbcglobal-dot-net>
 >  >
 >  > Kreso I've tried that and the PSU just goes into protection and makes a
 > 5mm
 >  > spark at 2hz.
 >  >
 >  > Regards - Jim Mitchell
 >  > ----- Original Message -----
 >  > From: "Tesla list" <tesla-at-pupman-dot-com>
 >  > To: <tesla-at-pupman-dot-com>
 >  > Sent: Thursday, April 15, 2004 6:22 PM
 >  > Subject: Re: Flyback Driver PCBs
 >  >
 >  >
 >  >  > Original poster: Kreso Bukvic <kreso.bukvic-at-kc.htnet.hr>
 >  >  >
 >  >  > I invite anybody to try my setup up. It will bring HUGE sparks.
 >  >  >
 >  >  > Here are the steps:
 >  >  >
 >  >  > 1. Get yourself a PC SMPS i used AT 200 W
 >  >  > 2. Toke the board out.
 >  >  > 3. Remove ferite cored transformer
 >  >  > 4. Connect flyback  primary to the points where primary of
transformer
 >  > under
 >  >  > 3 were.
 >  >  > 5. Apply power
 >  >  >
 >  >  > Best Regards
 >  >  >
 >  >  > Kreso Bukvic
 >  >  > ----- Original Message -----
 >  >  > From: "Tesla list" <tesla-at-pupman-dot-com>
 >  >  > To: <tesla-at-pupman-dot-com>
 >  >  > Sent: Thursday, April 15, 2004 4:26 PM
 >  >  > Subject: Re: Flyback Driver PCBs
 >  >  >
 >  >  >
 >  >  >  > Original poster: Brett Miller <brmtesla2-at-yahoo-dot-com>
msnip.......