[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Help needed with voltage divider



Original poster: "Ed Phillips" <evp-at-pacbell-dot-net> 

The tube and caps are plexiglass. The electrodes and grid are of copper.
Solderings are embedded in epoxy.
This is only a 70 cm long prototype. After measuring its step response,
if satisfactory, I'll build a 3 meter long version of it.

Note that even if the fluid conductivity changes, the divider ratio
remains unchanged as the grid position is always the same. Of course the
resistance must not go too down otherwise it will load too much the TC.

Best Regards"

	OK.  Missed the divider part.

Ed