Re: Primary Supports - Ball Cutter Question

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "S&JY" <youngsters-at-konnections-dot-net> 

Adam,

You don't need a ball cutter.  Just drill holes in your primary supports
slightly larger than your tubing diameter.  Then carefully saw through the
holes a bit above halfway up.   The holes will then look like a C with the
open side facing up. Viola, snap-in holes easily made.  I recommend using
HDPE cutting boards for the primary supports.  Easy to drill & saw, and
pliable enough to allow the tubing to be snapped in without damaging
anything.

--Steve Y.

----- Original Message -----
From: "Tesla list" <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Friday, June 11, 2004 7:30 AM
Subject: Primary Supports - Ball Cutter Question


 > Original poster: Yurtle Turtle <yurtle_t-at-yahoo-dot-com>
 >
 > >
 > Do ball cutters exist that would allow me to cut
 > deeper than halfway down in a single pass? If so,
 > where can I get one? (A cheap one.)
 >
 > thanks
 > Adam
 >
 >
 >
 >