[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: 2nd light of the "Green Monster" - sec vs. pri height
- To: tesla@xxxxxxxxxx
- Subject: Re: 2nd light of the "Green Monster" - sec vs. pri height
- From: "Tesla list" <tesla@xxxxxxxxxx>
- Date: Mon, 15 Aug 2005 22:55:25 -0600
- Delivered-to: testla@pupman.com
- Delivered-to: tesla@pupman.com
- Old-return-path: <vardin@twfpowerelectronics.com>
- Resent-date: Mon, 15 Aug 2005 22:56:42 -0600 (MDT)
- Resent-from: tesla@xxxxxxxxxx
- Resent-message-id: <h7FbND.A.ddE.KIXADB@poodle>
- Resent-sender: tesla-request@xxxxxxxxxx
Original poster: Kidd6488@xxxxxxx
yeah, i thought of that, but that would probably be even harder,
because the primary was wound AFTER the PVC supports were screwed
down. plus the connection is made of CU pipe that runs down and
around under the table.
it'd be worth a look tho, thanks
Jonathon
In a message dated 8/15/05 2:14:01 PM Eastern Daylight Time,
tesla@xxxxxxxxxx writes:
Hi Jonathon,
Instead of lowering your secondary, you could raise your primary to
achieve the same effect.