Re: Primarky design (was capacitor help)

["Tesla list" <tesla@xxxxxxxxxx>]

Original poster: "MalcolmTesla" <tesla@xxxxxxxxxxxxx>

----- Original Message -----
From: "Tesla list" <tesla@xxxxxxxxxx>
To: <tesla@xxxxxxxxxx>
Sent: Friday, December 16, 2005 6:23 PM


> Original poster: Esondrmn@xxxxxxx
>
> Malcolm,
>
> Very nice looking primary.  As long as everyone is chiming in with
> free advice - someday, you will like to have better access to the
> underside of the primary for adjusting the moveable tap lead.  I have
> my primary base cut out with pie sections missing between the primary
> tubing support ribs.  I see that you have holes in those areas but it
> will be hard to get your hand in there.  It will be easier to cut
> more of that wood out now before you get the secondary installed.
>
> Just a thought.  Keep up the good work.
>
> Ed Sonderman

Ed, thanks for the advice.  I did cut holes as you noted.  My secondary is
going to have a quick release setup.  Bolt with a wing nut so it can be
removed/installed in a snap.  I plan on taking my Tesla Coil around quite a
bit.

Thanks
Malcolm