[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Calibrating plane wave probes was RE: DRSSTC, OLTC...
- To: tesla@xxxxxxxxxx
- Subject: Calibrating plane wave probes was RE: DRSSTC, OLTC...
- From: "Tesla list" <tesla@xxxxxxxxxx>
- Date: Fri, 30 Sep 2005 18:29:31 -0600
- Delivered-to: testla@pupman.com
- Delivered-to: tesla@pupman.com
- Old-return-path: <vardin@twfpowerelectronics.com>
- Resent-date: Fri, 30 Sep 2005 18:27:51 -0600 (MDT)
- Resent-from: tesla@xxxxxxxxxx
- Resent-message-id: <YeG4AC.A.Z4B.GgdPDB@poodle>
- Resent-sender: tesla-request@xxxxxxxxxx
Original poster: Steve Conner <steve@xxxxxxxxxxxx>
The frequency response goes all the way down to like 16Hz.
Gosh, I never thought it went down that low :-o But I suppose if it
has a 0.02uF cap in it and the scope has a 1M Ohm input impedance,
the time constant is there. I don't think my ghetto probe goes
anywhere near that low though.
I recently got a NST so I'm cool with the NST calibration method.
Steve Conner
http://www.scopeboy.com/