Re: Power Arcing Was: SRSG questions

["Tesla list" <tesla@xxxxxxxxxx>]

Original poster: "D.C. Cox" <resonance@xxxxxxxxxx>



I have seen it occur on a standard axial electrode arrangement when 
the pps were too low due to slow motor speeds or too many electrodes.

Dr. Resonance


----- Original Message ----- From: "Tesla list" <tesla@xxxxxxxxxx>
To: <tesla@xxxxxxxxxx>
Sent: Tuesday, March 28, 2006 8:38 PM
Subject: Power Arcing Was: SRSG questions


> Original poster: "Barton B. Anderson" <bartb@xxxxxxxxxxxxxxxx>
>
> Power Arcing Question:
>
> Has anyone noticed power arcing with RSG's when a conductive ring is 
> not used? Just curious if this is a side affect contained only to 
> conductive rings on the discs. I haven't experienced it and I don't 
> use conductive rings.
>
> Thanks,
> Bart
>
>
> Tesla list wrote:
>
> > Original poster: BunnyKiller <bunikllr@xxxxxxx>
> >
> > power arcing is when you really punch up the power and the arc that 
> > is created at the disc electrodes and the stationary electrodes 
> > continue to transfer electricity even after the spinning ( disc) 
> > electrodes have gone past the point of "self exstinguishing" the 
> > present arc ...
> > my SRSG employs a copper ring between the 4 disc electrodes and 
> > there are pit marks well beyond an inch past the electrode where 
> > the hi power arcs have traveled on the copper band.....  but then 
> > again Im pushing close to 38KV thru my system at full throttle...
> >
> > Scot D