[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: SISG first sparks!



Original poster: Vardan <vardan01@xxxxxxxxxxxxxxxxxxxxxxx>

Hi Karl,

If it can take say 800 amps peak and the sections can be stacked to say 30kV then it should be able to run just about any normal conventional coil. In my case, I am working on about a 270 watt system since that is what I easily can put together.

Cheers,

        Terry


At 06:06 AM 5/16/2006, you wrote:
Hi Terry,

Your SISG experiment is great. This new electronic spark gap would be perfect for those of us that wanted to try a SSTC or DRSSTC, but were put off by the complexity of the electronics. What is your ultimate power goal? 1000 watts? Using MOT's and secondary capacitive ballasting gives you a wide range of power levels to run at.

Karl

On May 15, 2006, at 7:43 PM, Tesla list wrote:

Original poster: Vardan <vardan01@xxxxxxxxxxxxxxxxxxxxxxx>

Hi,

I still used the "full" bridge configuration. The two diode configuration gives only half the voltage but maybe twice the current. I need all that voltage I can get!!.

I am just using 8 x 1N5408 diodes per leg. 32 of them only cost a little over $5 ;-)) Like MMCs, just drill some holes in an insulating board to mount them.

http://www.drsstc.com/~sisg/SISG.pdf

Cheers,

        Terry




Hi Karl,

At 04:27 PM 5/13/2006, you wrote:
Hi Terry, Gerry, all;

If the SISG if it works as well as we all hope, it will suddenly give a new lease on life to all of those MOT's we we have laying around. Couldn't you connect the cores of two MOT's together, and bring out the HV secondary leads to double the voltage, and then make a full-wave bridge rectifier using two HV diodes on those leads in a center-tapped rectifier design? If that works, we may not need those hard to find NST's anymore.

Keep up the great innovations Terry!

Karl

I ended up doing this for my SISG coil ;-))

I put the details in that last few pages of the updated PDF file here:

 http://www.drsstc.com/~sisg/SISG.pdf

I will try to keep that file updated. Parts are on order today so not much will happen till Thursday. I will be remounting the MOTs, working on the diode bridge, and making a new MMC for it...

Cheers,

        Terry