[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: Big Toroids, collective conscious brain storm



Original poster: "Jim Mora" <jmora@xxxxxxxxxxx>



-----Original Message-----
From: Tesla list [mailto:tesla@xxxxxxxxxx]
Sent: Tuesday, September 12, 2006 7:35 AM
Hello all,

Lets use the List group consensus to brain storm a way to make an economical
large toroid within reasonable effort that is strong, light, and smooth
enough to do the Saint Vitas Dance.

My limited experience proves that attaching a smaller diameter, say 4" minor
of  dyer duct by 18 or 19" (scale as needed) added surprising plane rigidity
to the 8" x 32"+ business end toroid with dual pizza pans center. This
clearly reinforces the top hat which is still reasonably horizontal with no
visible plane distortions.

Ok, so we are down to the filling the ridges, and dent deterrent.

Bondo.

I grew up in Illinois, and became proficient in rust repair. It is very
formable and reducible in early set stages. Hey, there have to be more
solutions out there in today's high tech, divisive chemistry and epoxies.

I have to believe that there is spray on, reasonably low resistance coatings
at our voltage outputs.

Ideas folks?

Jim Mora
"Better Living through Science"





To: tesla@xxxxxxxxxx
Subject: Re: Big Toroids

Original poster: Gomez Addams <gomezaddams@xxxxxxxxx>


<snip>