[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [TCML] Terry filters



Even if you were running 26KVA continuously, at 14.4kV, the high-side current is only 1.8 Amps, and 12AWG seems way larger than necessary.

Gary Lau
MA, USA

> -----Original Message-----
> From: tesla-bounces@xxxxxxxxxx [mailto:tesla-bounces@xxxxxxxxxx] On
> Behalf Of resonance@xxxxxxxxxxxx
> Sent: Monday, December 31, 2007 7:29 PM
> To: Tesla Coil Mailing List
> Subject: RE: [TCML] Terry filters
>
> Yes.  Due to high 26 kVA power level we used 12 AWG wire.  At 5-10 kVA
> power level a good 16 or 18 AWG PVC covered wire is fine.   A bit of
> resistance in using the smaller dia wire is good too as it adds a small
> amount of resistance which further squishes the transients.
>
> Dr. Resonance
>
> > DC,
> > I seem to remember you using and air core on the HV going out to Big
> > Bruiser
> > and the rotary. It was like 4"x30" wound with house wire? Is that about
> > right?
> >
> > Thanks,
> > Jim Mora
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla