Re: ARSG-BPS required with 2 MOTs?

["Tesla list" <tesla@xxxxxxxxxx>]

Original poster: "resonance" <resonance@xxxxxxxxxxxx>


Run approx 350 to 400 pps.

1725 rpm / 60 rev / sec = 28.75 rev /sec.

12 electrodes on the rotor would give you 375 pulses per second --- a 
good value to use with MOTs.

Run a 10 inch dia rotor with the 12 electrodes on a 9 inch dia spacing.

As long as you have a very large cap value in the voltage doubler to 
provide a lot of current to drive your tank circuit caps, the 375 pps 
will "grow" some awesome plasma sparks!

Dr. Resonance


> Original poster: nancylavoie@xxxxxxxxxxx
> I've recently built a 2 MOT power supply complete with a voltage 
> doubling set up and capacitive current limiting deal per Greg 
> Hunters awesome site.Want to try it out on both of my already built 
> coils (ones a 4" and the other is a 6" secondary).Its pretty obvious 
> to me that the old static gap and vacuum motor I was using with my 
> neons isn't going to cut it anymore.What I want to know is how 
> exactly do I calculate the ideal BPS for such a set-up and how do I 
> achieve this with an asynchronous motor turning 1725 RPM? Thanks in 
> advance! Wyatt