[TCML] 6x24 spun toroid bulk buy, anyone?

["David Rieben" <drieben@xxxxxxxxxxx>]

Hi all,

I am making gradual progress in my mid-sized SG driven coil
project and am beginning to think about a top load for it. Al-
though the dryer duct toroid is certainly the most economical
answer for a top load, it is not very asthetically pleasing and
is also too dent proned and fragile. I would like to get a 6x24
spun toroid and was hoping to get enough interest to pursue
a bulk buy  from O.W. Landergren to help somewhat reduce 
the cost. Any takers?

David Rieben
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla