Re: [TCML] Strike Rail Hits Was: Stacking vs Large Diameter

["Mike H" <mike8675309@xxxxxxxxx>]

On Mon, Jul 14, 2008 at 9:13 PM, bartb <bartb@xxxxxxxxxxxxxxxx> wrote:
> Hi David,
>
> I'm in the process of building a ribbon primary. The ribbon is 1" x .035" x
> 50ft. I'm building this for the SISG coil (since I'm waiting on more diodes
> as I decided on full bridge capable of 60kV rectification). The inner
...

Bart,

I've noticed in the pictures on this thread, that the copper ribbon
being used seems to be quite a bit thicker than the .035" ribbon you
have.  Is there any concern to be had about using a thinner ribbon vs
a thicker one?  Any adjustments necessary to design or calculations
based on this?
i.e. this picture:
http://home5.inet.tele.dk/f-hammer/tesla/ambassador/primary/primary4.jpg
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla