Re: [TCML] RE: Primary coil supports

[Yurtle Turtle <yurtle_t@xxxxxxxxx>]

I used FRP perfboard and I had no problem with
buckling:

http://www.hot-streamer.com/adam/mmc1.jpg

Adam

--- Troy Peterson <troypeterson@xxxxxxxxxx> wrote:

<snip>
> As for MMC construction - I think the main reason
> that most people use 
> plastic rather than perf board is that it just looks
> nicer. And the 
> holes on most standard perf board may not be big
> enough to accept the 
> mmc cap leads without some help. Also, perfboard is
> really flimsy and 
> will buckle under the weight of a load of MMC caps
> without good 
> support... But there's no reason that it can't be
> used.
> 
> Cheers,
> Troy.
> 



      ____________________________________________________________________________________
Looking for last minute shopping deals?  
Find them fast with Yahoo! Search.  http://tools.search.yahoo.com/newsearch/category.php?category=shopping
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla