Re: [TCML] BIGPIG secondary dies...

[bartb <bartb@xxxxxxxxxxxxxxxx>]

Hi Scot,

6.7 turns versus 13.7 is off far enough that there is likely an input 
that is incorrectly entered, but I can only guess without "specs" of 
some type. Can you send me some specs? In Javatc, each output text is 
link for a pop-up of the output description.

Take care,
Bart

bunnykiller wrote:
> Hey All...
>
> Finally after 9 or so years of service, the BIGPIG secondary died, and 
> I must say impressively at that. There was an arc that formed between 
> windings near an older repair job which caused " a small fire" ;) 
> seems the Behr 50 coating is flamable to some degree!
>
> Anyway I was considering a rebuild of the coil and began playing 
> around with JavaTC and I was getting some conflicting info compared to 
> WinTesla outputs. Javatc states a 6.7 turn primary as compared to 13.7 
> in Wintesla all parameters being the same for all hardware involved. ( 
> and considering that the BIGPIG was tuned to 13.5 turns and worked 
> well ). Why the difference between the 2 programs on tuning point?
>
> And for last...  is there some very definative info on JavaTC 
> terminology so I can figure out what is meant in the output fields of 
> the primary and secondary calculated sheets??
>
> Scot D
>
>
>
>
>
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla