RE: [TCML] Ballast -- Before or After Variac?

["Jim Mora" <wavetuner@xxxxxxxxx>]

Hi Jeremy,

I believe it is traditional to place the ballast after the variac
(downstream), otherwise you are ballasting the variac too. This way, you can
get full voltage and limit the current as desired... interesting issue
though. Jim Mora

-----Original Message-----
From: tesla-bounces@xxxxxxxxxx [mailto:tesla-bounces@xxxxxxxxxx] On Behalf
Of Jeremy Scott
Sent: Monday, April 27, 2009 1:31 PM
To: tesla@xxxxxxxxxx
Subject: [TCML] Ballast -- Before or After Variac?



Hi all,

I was just wondering where the optimal place in the circuit is for the
ballast?

Should it go in series with the variac input, or series with the variac
output? 

Modeling it in SPICE, it appears to function either way. 

The ballast is an arc welder with a range of 6mH to 18mH (measured), 
output terminals shorted.

The variac is a 30A Powerstat with an input of 125mH to an output range 
of 0-180mH (measured - 120VAC in, 0-140VAC out.)

I haven't hooked it up and measured the output for real yet, but SPICE
modeling shows some interesting results:

When placed AFTER the variac on the variable voltage line, it limits current
to 35A on the low end to 50A on the high end. 

When placed BEFORE the variac on the 120VAC voltage line, it limits 
current to 28A on the low end to 45A on the high end.

So, both results look okay -- this is a 50A circuit, so which is best?



      
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla