[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
RE: [TCML] Calibrating a sync spark gap
Karl,
I do hope you meant Tungsten and not titanium which melts at 3000 degrees F
verses 6092F. Titanium also burns in air at 2000 degrees or so. An arc gap
can reach 10,000 F
Jim Mora
-----Original Message-----
From: tesla-bounces@xxxxxxxxxx [mailto:tesla-bounces@xxxxxxxxxx] On Behalf
Of Karl Thorkildsen
Sent: Sunday, January 25, 2009 10:38 AM
To: tesla@xxxxxxxxxx
Subject: [TCML] Calibrating a sync spark gap
I'm in the process of building a synchronous spark gap. I have
modified a motor and built a rotor from G10. My electrodes are
mounted by drilling a hole the long way through a bolt, then drilling
a hole sideways into the head and tapping for a set screw. The bolts
are mounted through the G10 with some washers as cooling fins, and
titanium rods stuck through held in place with the set screws. I'll
upload some pictures later and link to them.
The problem is how to set the position correctly. Here's what I did:
Hook up an NST to the gap and connect one channel of my scope to the
AC line of the NST (actually going through a variac too). I took a
piece of hookup wire, alligator clips on the ends, and wrapped it
around one of the output wires of the NST, about 5 wraps. The ends
of this wire go across the other channel of the scope, signal to
gnd. Basically I built a cheap current probe.
Now firing the thing up, I set the scope to trigger on the current
probe. Basically getting a pulse every time the gap lines up. And
looked at the position of the AC line voltage relative to the pulse.
Using this method I got a fairly consistent display on the scope and
was able to adjust the position by rotating the motor in the mount.
Question, I think I remember reading that I should sync to about 85%
of peak. In other words it should fire a little early, is that right?
- Karl
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla