[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [TCML] Capacitor encapsulent



Hi Jim,

I've not personally experienced it, but I had assumed that plate glass failure in a cap was just due to localized heating from corona fracturing the glass.  How hot does glass have to get to become conductive?

One further point regarding the original plan - Using brass for the plates is expensive and unnecessary.  Aluminum foil or flashing is electrically perfectly adequate and a lot cheaper.  The only down side is that one can't solder directly to it.

Regards, Gary Lau
MA, USA

> -----Original Message-----
> From: tesla-bounces@xxxxxxxxxx [mailto:tesla-bounces@xxxxxxxxxx] On
> Behalf Of jimlux
> Sent: Saturday, May 23, 2009 11:28 AM
> To: Tesla Coil Mailing List
> Subject: Re: [TCML] Capacitor encapsulent
> 
> 
> >
> > Hi Raymond,
> >
> eading to degradation, tracking,
> > and eventual failure of your capacitor. Any hot spots in the dielectric
> > become increasingly electrically conductive, which can also lead to
> > localized thermal runaway, punch through, and shorting of the
> > dielectric.
> 
> > Bert
> >
> 
> I completely forgot about that.. hot glass is a conductor.
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla