[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
RE: [TCML] pulse caps for large DRSSTC
Very nice, that would explain why they work. Are they oil immersed? Who
is the manufacturer? Do you have any satisfied customers you could refer
us to? Nothing better than a "third party report".
FYI: I have run my Stroker II, 1/2-bridge CM600 on a "brutally hard",
high bit rate 30 min run using Dr. Spark's design. Cap bank was ice
cold, primary quite hot. So what duty factor were you using on your 10
From: tesla-bounces@xxxxxxxxxx [mailto:tesla-bounces@xxxxxxxxxx] On
Behalf Of DC Cox
Sent: Friday, September 18, 2009 6:27 AM
To: Tesla Coil Mailing List
Subject: Re: [TCML] pulse caps for large DRSSTC
I have already tested them in DRSSTC service. They work excellent. We
checked thermal rise with an infrared camera. No problems after
10 minute runs.
They are comprised of series sections and parallel sections to spread
the thermal load over a large area.
On Thu, Sep 17, 2009 at 4:25 PM, Dave Leddon <dave@xxxxxxxxxx> wrote:
> Dr. Resonance,
> If you would be willing to provide to me, free of charge, a sample of
> one of these capacitors, I would be willing to verify their
> DRSSTC service. Failing that, I would be willing to join a group buy,
> should some generous soul be willing to set it up (i.e., somebody
> At 09:32 AM 9/17/2009, you wrote:
>> I carry high-Q factor heavy duty pulse caps for medium and large
>> SSCAP-200 measures 3 3/4" x 5" x 11" and is very conservatively rated
>> (800 nF) at 20 kV WVDC.
>> SSCAP-400 measured 3 3/4" x 5" x 11" and is conservatively rated 1 uF
>> kV WVDC.
>> Designed for continuous operation at 12 kV DC in H-bridge
>> Contact me off-list for further information. If someone assembles a
>> buy" I can provide pricing around $390 per cap.
>> Dr. Resonance
>> Tesla mailing list
> Tesla mailing list
Tesla mailing list
Tesla mailing list