[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[TCML] Cutting Garolite disk




Ok,
So I'm making a srsg and I am convinced of the primacy of garolite as the material to use for the disk holding the spinning electrodes. But as far as I can tell my sources of garolite will all provide square or rectangular chunks (eg - mcmaster-carr)

What's the best technique to cut a precise circle out of these square pieces?

I don't have a band saw...

Thanks in advance
Joe

Sent from Joe's mobile phone.
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla