[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [TCML] DIY dent-proof Toroids



Perhaps "spin-balancing" while it cured would solve some of the distribution problem, especially if done in several steps, building towards the inside to allow proper out-gassing. When in a confined space with some air, the out-gassed fumes from "Great-Stuff" foam are nicely explosive!


Matt D.



-----Original Message-----
From: dave pierson <dave_p@xxxxxxxxxxx>
To: Tesla Coil Mailing List <tesla@xxxxxxxxxx>
Sent: Mon, May 27, 2013 11:55 am
Subject: Re: [TCML] DIY dent-proof Toroids


I am speculating a bit, however:

  Some foam plastics are quite flammable.

I'd not like to see one light off on top of a coil...

best

dwp
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla

 
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla