Hi Kuba,
I couldn't quite understand the wiring of the MMC caps and bleeder
resistors. It looks like you have a 10 Ohm resistor is series with each
cap. It should be a 10MegOhm resistor in parallel with each cap. I assume
this is just a typo/graphical error?
Regards, Gary Lau
MA, USA
On Wed, Mar 26, 2014 at 8:44 PM, Kuba Anglin <kubaanglin@xxxxxxxxx> wrote:
> I am about to wire up my Tesla coil and just wanted to check if I have it
> right before I start attaching wires. Here is my sketch:
> http://postimg.org/image/kchnxc2cz/
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla
>
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla