[Home][2015 Index] Re: [TCML] VDG pickups (was Ignition coil driver) [Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [TCML] VDG pickups (was Ignition coil driver)



Jim,
I've never tried this with a HV fed comb, but wouldn't that give an uneven charge on the belt, or isn't the difference large enough to matter?

    Derek

On 24-Dec-15 10:28 PM, Jim Lux wrote:
On 12/24/15 5:56 AM, ExtremeElectronics.co.uk wrote:
Stefan.
     Initially I decided to go with the traditional build. Id had my
fill of electronics and wanted something different (I then built a uP
speed control for the motor)

     So,  hair dryer v High voltage supply.

I've thought about it, but I'd need to change my bottom roller to
Aluminum. I don't have the workshop tools to make another crowned
roller. The last two rollers were machined for me, so it will have to
wait until someone with a lathe owes me a favour..


You can wrap tape around the roller to make a crown. All it needs to be is a bit bigger in the middle than on the sides.

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla