[Home][2018 Index] Re: [TCML] Bad strike to a 12 inch traditional coil (somewhat terminal) [Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [TCML] Bad strike to a 12 inch traditional coil (somewhat terminal)



Hello Phil,

Ouch! That strike looked really destructive, as in much more than a few damaged secondary turns. At an operating power of 4.8 KVA, I have had a few brief strikes to my secondary with no apparent damage, but nothing like this. I wish we could all figure out a way to prevent these but there probably isn't a way with these power levels.

Steve

----- Original Message -----
From: "phil" <pip@xxxxxxxxxxx>
To: tesla@xxxxxxxxxx
Sent: Wednesday, July 4, 2018 8:48:19 AM
Subject: [TCML] Bad strike to a 12 inch traditional coil (somewhat terminal)

Gents & Lassies

Slightly odd one, with a video at:  https://youtu.be/tcESWWbcr7I

This recently occurred to Phil S's 12 inch coil that on the day in 
question, and also the previous day, had ran fine. Tuning had been done 
with an oscilloscope, and the coil was not considered over-coupled. The 
winding had though sustained previous damage which had been repaired a 
year previously, however this latest damage did not appear to align with 
where the previous splice had been done, and as mentioned, it had 
already had some higher power runs that day.
As you will see there was already a streamer strike "in progress" (so as 
to speak) from the  toroid down to the primary strike-ring when the 1st 
secondary flash-over up the winding occurs. This finished around 30m/s+ 
later and then a second flash-over occurs fairly soon after.
This time however the ongoing toroid-to-strike-ring streamer (which had 
started 0.5 second or so before the 1st flash-over) now forks over to 
join the secondary flash-over. Then the fun really begins!

Were these flash-overs a result of the initial strike to the 
strike-ring, or just coincidence?
Initial thoughts were it looked like so called 'racing sparks', but they 
did not initially  extend up the winding very far, so jury is still out.
Coil is 100 bps SRSG using a phase controller.


Phil T
(Luddite Coiler UK)
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxxxxxx
https://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxxxxxx
https://www.pupman.com/mailman/listinfo/tesla