Re: SRSG machineing

[FutureT-at-aol-dot-com (by way of Terry Fritz <twftesla-at-uswest-dot-net>)]

In a message dated 8/4/00 11:44:41 AM Pacific Daylight Time, tesla-at-pupman-dot-com 
writes:

> 
>  That is a little lower than the 1/4 HP I use but I think it will still work
>  fine.  I think John Freau had a little trouble with low HP motors but I
>  think they were far smaller.

Terry, all,

I've used 1/4HP, and 1/10 HP induction motors (modified) with no
problem.  But I had a problem with a small fan motor of unknown HP.  

Cheers,
John Freau