[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Polyurethane (fwd)

To: tesla@xxxxxxxxxxxxxxxxx
Subject: Polyurethane (fwd)
From: "Tesla list" <tesla@xxxxxxxxxx>
Date: Tue, 5 Dec 2000 11:29:43 -0700 (MST)
Resent-Date: Tue, 5 Dec 2000 11:29:48 -0700
Resent-From: tesla@xxxxxxxxxx
Resent-Message-ID: <c_YiQB.A.lYC.XQTL6@poodle>
Resent-Sender: tesla-request@xxxxxxxxxx

Original poster: Tesla List Moderator <mod1@poodle.pupman.com>

---------- Forwarded message ----------
Date: Tue, 5 Dec 2000 11:14:33 EST
From: Esondrmn@aol.com
To: tesla@pupman.com
Subject: Polyurethane

I plan to re-wind my small coil this weekend.  The form is acrylic.  Does 
anyone know if polyurethane (oil based) will attack acrylic?  I know some 
solvents will cause acrylic to crack, like thousands of small cracks 
(craze?).  Does anyone have an acrylic form with polyurethane on it?

Thanks,

Ed Sonderman

Prev by Date: Re: Saturable Reactor Repost?? (fwd)
Next by Date: RE: Secondary wire q / Ozzie 2nd hand-NSTs? (fwd)
Prev by thread: Re: Saturable Reactor Repost?? (fwd)
Next by thread: RE: Polyurethane (fwd)
Index(es):
- Date
- Thread