Re: New Secondary

["Tesla list" <tesla@pupman.com>]

Original poster: "teri mckenney by way of Terry Fritz <twftesla@uswest.net>" <mck@ezy.net>

In the woodshop where I work we "flame" out the bubbles with a propane
torch.E-mail me if you want more details.
billy
-----Original Message-----
From: Tesla list <tesla@pupman.com>
To: tesla@pupman.com <tesla@pupman.com>
Date: Monday, December 11, 2000 7:11 PM
Subject: RE: New Secondary


>Original poster: "Basura, Brian by way of Terry Fritz
<twftesla@uswest.net>" <brian.basura@unistudios.com>
>
>Make sure to NOT stir in bubbles when mixing this type of material. That's
>where most of them come from...
>
>Regards,
>Brian B.
>
> -----Original Message-----
> From: Tesla list [mailto:tesla@pupman.com]
> Sent: Monday, December 11, 2000 3:26 PM
> To: tesla@pupman.com
> Subject: New Secondary
>
> Original poster: "by way of Terry Fritz <twftesla@uswest.net>"
><Esondrmn@aol.com>
>
> Well, I re-wound my 3.0" secondary this weekend.  I used # 28 wire again
and
> used the same winding length of 13".  I finished it with some clear two
part
> epoxy material that is sold for making clear counter tops.  Similar to
Behr
> build 50, I believe.  I have to agree with all of you that have commented
on
> this stuff.  It goes on thick with one coat and dries clear.  Looks very
>good
> and definitely thicker than 10 or 20 coats of polyurethane.  I do have
lots
> of small air bubbles in the dried material that I could not get out, but I
> think it is ok.
>
> Ed Sonderman
>
>
>
>
>
>