[Prev][Next][Index][Thread]
Re: Scot's spark gap in progress
-
To: tesla@pupman.com
-
Subject: Re: Scot's spark gap in progress
-
From: "Bunnykiller" <bigfoo39@idt.net> (by way of Terry Fritz <twftesla@uswest.net>)
-
Date: Sat, 26 Feb 2000 12:13:27 -0700
-
Approved: twftesla@uswest.net
-
Delivered-To: fixup-tesla@pupman.com@fixme
Snippp
Hi Ralph...
yes you are right it is 1/2 of the dia. of the tube dia. for spacing
as far as softening ... i use 1 screw per tube and that screw does
get warm and with no means of securing the tube else wise i felt that
the base material where the screw goes thru would possibly soften/loosen
and the tubes might move , also since there is the intermittent
heat/cool cycles, the nuts could also possibly loosen ( use lock washers
if you have them) other than that im happy with the design :)
Scot D