[Prev][Next][Index][Thread]
Re: Grinding sync motors with an angle grinder :-))
-
To: tesla@pupman.com
-
Subject: Re: Grinding sync motors with an angle grinder :-))
-
From: "Jim Lux" <jimlux@earthlink.net> (by way of Terry Fritz <twftesla@uswest.net>)
-
Date: Sat, 20 May 2000 09:08:20 -0600
-
Approved: twftesla@uswest.net
-
Delivered-To: fixup-tesla@pupman.com@fixme
>
> My rotor is 3.2226 inches across. I am cutting flats 0.850 wide. My 1/4
> HP A.O. Smith motor has 36 metal chunks in the outer motor part (not the
> rotor).
That's called the field..
I am measuring from center-of-flat to center-of flat on four of
> them. There are three notches with the skinny wires in between notches
> with the heavy wire. The metal chunk with a heavy winding on one side
and
> a skinny one on the other is were you measure from. I guess these are
the
> "half dead" poles. ;-))
Those are called "salient poles"