Re: Epoxy breakdown voltage -Reply

• To: tesla-at-pupman-dot-com
• Subject: Re: Epoxy breakdown voltage -Reply
• From: ROBERT CRESSLER <59CREROB-at-menasha-dot-com> (by way of Terry Fritz <terryf-at-verinet-dot-com>)
• Date: Mon, 05 Oct 1998 18:06:07 -0600
• Approved: terryf-at-verinet-dot-com

       You may wish to contact the 3M corp. They have in depth technical
parameters on  their line of epoxy adhesives....
electrical,thermal,chemical,you name they have info on it.
robert

>>> <tesla-at-pupman-dot-com> 10/03/98 04:35am >>>
Original Poster: Doug Brunner <dabrunner-at-earthlink-dot-net> 

Thanks a lot. I haven't been able to find that spec anywhere. Just a
millimeter....!! Now all I have to do is find the epoxy...

Tesla List wrote:

> Original Poster: Steve Rodway <Legion-at-bigfoot.c
> Tesla List wrote:
>
> > Original Poster: Doug Brunner <dabrunner-at-earthlink-dot-net>
> >
> > Does anyone know what the breakdown voltage for epoxy (not
plumber's) is
> > like?
>
>     Depends on the type, but around 15-20Kv/mm
>
> --
> **********************************************************************
> *Stephen Rodway             Legion-at-Bigfoot-dot-com *  Support your local *
> *Tel. 01761 300615                             *     coroner....     *
> *For Email use PGP where possible.             *    Die strangely!   *
> *http://www.legion-elec.demon.co.uk/index.htm  *                     *
> **********************************************************************



--
           --Mr. Postman (Doug Brunner)
                <dabrunner-at-earthlink-dot-net>

• Prev: Re: Self-built power transformer (some design parameters)
• Next: Re: Is high coil frequency a bad thing?
• Index(es):
  • Main
  • Thread