[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Machining SRSG disk ?

To: tesla-at-pupman-dot-com
Subject: Machining SRSG disk ?
From: "Tesla list" <tesla-at-pupman-dot-com>
Date: Tue, 23 Jul 2002 20:27:37 -0600
Resent-Date: Tue, 23 Jul 2002 20:28:54 -0600
Resent-From: tesla-at-pupman-dot-com
Resent-Message-ID: <DKmv2D.A.13F.kDhP9-at-poodle>
Resent-Sender: tesla-request-at-pupman-dot-com

Original poster: "Bryan Steinbach by way of Terry Fritz <twftesla-at-qwest-dot-net>" <hal-9000-at-telocity-dot-com>

List,
	I'm interested in building a SRSG for a small 15/30 NST powered coil.  What 
level of precision is necessary for the disc?  My motor is 1800RPM and I'm 
considering 3" radius and 4 electrodes(120bps) on a 2.5" radius.  However, 
the motor is only 10W.  Will it be able to spin this up without needing a 
boost?
Thanks,
Bryan Steinbach

Prev by Date: Off-Line Tesla coils (OLTC)
Next by Date: Re: SSTC As a transmitter.
Prev by thread: RE: Materials / Method for Conductive SRSG Ring
Next by thread: Re: Machining SRSG disk ?
Index(es):
- Date
- Thread