[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: overcoupling

To: tesla-at-pupman-dot-com
Subject: Re: overcoupling
From: "Tesla list" <tesla-at-pupman-dot-com>
Date: Wed, 24 Sep 2003 17:09:21 -0600
Resent-Date: Wed, 24 Sep 2003 17:15:30 -0600
Resent-From: tesla-at-pupman-dot-com
Resent-Message-ID: <RSjeQC.A.woD.IWic_-at-poodle>
Resent-Sender: tesla-request-at-pupman-dot-com

Original poster: "Dr. Resonance" <resonance-at-jvlnet-dot-com> 

Use a 24 x 5 or 24 x 6 inch toroid (twice sec. coilform dia.).  For primary
use a flat spiral.  First pri turn to coilform distance set at 1.25 inches.
First sec. turn should be elevated approx 2.25 inches above the horizontal
plane of the pri coil.

Don't make a fixed pri to start --- use some scrap 12 AWG wire, around 20
turns, tap as necessary, to test prior to final fabrication of pri coil.

Dr. Resonance

Resonance Research Corporation
E11870 Shadylane Rd.
Baraboo   WI   53913

Prev by Date: Re: skin depth
Next by Date: Re: skin depth
Prev by thread: Re: overcoupling
Next by thread: Re: overcoupling
Index(es):
- Date
- Thread