Re: non sync rotary.....

["Tesla list" <tesla@xxxxxxxxxx>]

Original poster: "david baehr" <dfb25@xxxxxxxxxxx>


Yes, I had the same problem with my Ol' 8" 
coil,..if I added extra gaps in addition to the 
two gap rotary, it would not run right, I had to 
use the rotary only, and then adjust to the 
absolute min. spacing! ,(there is a video of that 
coil running on an old R. Hull tape, I named it 
'Tempest') maybe I need a larger dia. disk 
?,...the eight  spinning electrodes are 7" point 
to point , not sure on RPM, i use a 12v heater 
blower motor but feed it up to 24v, this was my junk box rotary :-)

From:  "Tesla list" <tesla@xxxxxxxxxx>
To:  tesla@xxxxxxxxxx
Subject:  Re: non sync rotary.....
Date:  Sat, 03 Mar 2007 14:42:01 -0700
>Original poster: "David Rieben" <drieben@xxxxxxxxxxxxxxx>
>
>Hi David, all,
>
>I hitch, assuming proper gap spacing. It's just the
>async rotary gaps that I have never been able to get to run right
>with 2 pairs of stationary electrodes.? Anyone like to try to tackle
>this one again?
>
>David Rieben
>



----------
<http://g.msn.com/8HMAENUS/2728??PS=47575>Find 
what you need at prices you?ll love. Compare 
products and save at MSN® Shopping.