RE: [TCML] Table Saw Blades for Phenolic LE

["Mccauley, Daniel H" <daniel.h.mccauley@xxxxxxxx>]

And i really liked that smell!!!

Dan




I saw several comments about the dust , well I think the smell of the
Phenolic being cut will provide a clue it is not good to inhale and a
fan and mask are needed. I have cut it with a 60 tooth plywood blade.
	Rich

-----Original Message-----
From: tesla-bounces@xxxxxxxxxx [mailto:tesla-bounces@xxxxxxxxxx] On
Behalf Of Mccauley, Daniel H
Sent: Sunday, February 10, 2008 6:18 PM
To: Tesla Coil Mailing List
Subject: [TCML] Table Saw Blades for Phenolic LE

Anyone have experience with cutting LE Phenolic on a table saw.  Looking
for a blade recommendation for nice clean cuts.
Just acquired a truckload of this stuff from a surplus auction and
probably going to be building lots of stuff with it!

Thanks

Dan
 

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla