RE: [TCML] Could this be a breakout point?

["Stephen J. Hobley" <shobley@xxxxxxxxxx>]

Sorry that wasn't clear - what I meant to say was "what I had before" - that was why I changed it to what was shown in the picture.

Based on the feedback, I changed it again, now there's just a single wire spiraling up to the contact point. I changed the main bolt to I can now remove the toroid without risking moving the coil wire.

Thanks,
Steve 


www.stephenhobley.com
317 201 4281

The Laser Harp Project - www.stephenhobley.com/build



-----Original Message-----
From: tesla-bounces@xxxxxxxxxx on behalf of bartb
Sent: Sun 9/7/2008 10:46 PM
To: Tesla Coil Mailing List
Subject: Re: [TCML] Could this be a breakout point?
 
Steve, what I described is not what you showed in your picture to the 
TCML (it is not what you have now). You showed termination on the side 
of the form (a bolt). I described termination from a top cap. Very 
different as you don't have a top cap.

Regards,
Bart

Stephen J. Hobley wrote:
> My goal has been to terminate the coil wire on the cylinder. 
>
> The solution you describe is what I have now, and I'm concerned about
> the fragility of the coil wire.
>   
>
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla



_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla