Re: [TCML] op amp wiring

[Gabriel Cardona <cardogab7341@xxxxxxxxx>]

Scott,

Can you explain what you're trying to do?

1. What will the output of the op-amp be connected to and what voltage levels are needed at the op-amp output?
2. What voltage levels will be at the input to the op-amp?
3. What is the op-amp you're using (manufacturer and part number)?

With this information, it will be easier to help.

Regards,

Gabe Cardona


________________________________




________________________________
From: Scott Bogard <sdbogard@xxxxxxxxx>
To: Tesla Coil Mailing List <tesla@xxxxxxxxxx>
Sent: Wednesday, January 14, 2009 1:17:51 PM
Subject: [TCML] op amp wiring

Hey guys,
     I am in need of some assistance, I am doing an experiment with
flyback drivers, and the circuit I designed uses a Op-amp in a
comparator configuration.  The only problem is I know nothing about
actually wiring an Op-amp except for the extreme basics (inverting
pin, non-inverting pin, output) which I learned in school.  I do not
know how to connect it to the power supply, if I need negative
voltage, what the "offset" pins are for, what Vcc or Vss is, etc.  Any
help would be appreciated, there are 8 pins and I only know for sure
what 3 of them do, thanks.

Scott Bogard
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla