[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [TCML] ARSG Design



Check out the conductivity values for brass vs. aluminum at your designed
resonant freq.  You will find brass to be the clear winner.
Alum is only acceptable at 60 Hz power freqs.  Alum at your res freq will
limit the peak currents, which you want to be a maxiumum value for
almost any RF design.

The current in a series circuit is always limited by the max resistance
component at all points in the circuit.  Even small losses
begin to rapidly add up at RF frequencies.

Dr. Resonance




On Thu, Jul 9, 2009 at 8:01 PM, Andrew Robinson <teslamad@xxxxxxx> wrote:

> Check out these designs, I need some advice.
>
> Complete assembly:                  http://host.teslamad.com/assembly.jpg
> Stationary electrode insulator:    http://host.teslamad.com/Insulator.PDF
> Stationary electrode:
> http://host.teslamad.com/Electrode.PDF
> Rotary Disc:
> http://host.teslamad.com/Disk.PDF
> and ring for back of disc:            http://host.teslamad.com/Ring.PDF
>
> The stationary electrodes were going to be made of brass as was the
> conducting ring to connect the rotary electrodes, but I started thinking...
> Aluminum is probably a lot cheaper. Can anyone give me a good reason as to
> why I wouldn't want to use Al. Guess the question really is, why wouldn't I
> want to use Al. Its a better conductor than brass but softer if memory
> serves me correctly. Thanks for the input.
>
> Andrew Robinson
> www.teslamad.com
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla
>
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla