[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [TCML] New (er, rebuild) Project



Miles,

There are less expensive alternatives to G10 which are just as good, in my
opinion.  My RSG rotors are made of GP03 which is an electrical grade
fiberglass.  A few years ago a 12 x 12 x 3/8 inch sheet cost less than $10
from McMaster-Carr (part number 8549K372).  It machines well and is rated
for use up to 400 degrees F.

Steve Y.

-----Original Message-----
From: tesla-bounces@xxxxxxxxxx [mailto:tesla-bounces@xxxxxxxxxx] On Behalf
Of Miles Mauldin
Sent: Monday, August 02, 2010 7:28 AM
To: Tesla Coil Mailing List
Subject: [TCML] New (er, rebuild) Project

Hi All,
<SNIP>  As yet, 
I have not found a source (inexpensive) for G10/FR4 any pointers would be 
appreciated.
Miles M
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla
No virus found in this incoming message.
Checked by AVG - www.avg.com 
Version: 9.0.851 / Virus Database: 271.1.1/3045 - Release Date: 08/02/10
00:35:00

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla