if you have 1/2" spacing and say 6 spokes. 1/2" / 6 = .083". stack them up like a stare way with .083 treads, clamp and drill. if you already have them cut to length. if you have extra length , just cut the inside end accordingly .083 then 2x.083 then 3x.083 , etc.
hope this helps.
On Saturday, July 5, 2014 9:55 AM, t-burns14 <t-burns14@xxxxxxxxxxx> wrote:
I'm about to drill holes in my HDPE spokes and realized that if I drill all the holes in line, I'll end up with concentric circles and then a bent piece to get to the next circle level. Not good. So how do I do this properly in order to get an actual spiral?
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla