[Home][2014 Index] Re: [TCML] Radial Spoke Primary [Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [TCML] Radial Spoke Primary



I had eight spokes, so I divided the center by center dimension and divided that by 8. I stacked all eight,using the offset, and cut both ends flush.



________________________________
 From: t-burns14 <t-burns14@xxxxxxxxxxx>
To: tesla@xxxxxxxxxx 
Sent: Saturday, July 5, 2014 7:55 AM
Subject: [TCML] Radial Spoke Primary
 

I'm about to drill holes in my HDPE spokes and realized that if I drill all the holes in line, I'll end up with concentric circles and then a bent piece to get to the next circle level. Not good. So how do I do this properly in order to get an actual spiral?
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla