[Home][2018 Index] Re: [TCML] GF NST,s [Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [TCML] GF NST,s



The Ebay listing also shows that the resistors are wirewound. If the actual resistors in question are the same (presumably they are) I'm sure a little bit of inductance in the line helps protect the transformer from the nasty current spikes too.
MattFairlee, VT


-----Original Message-----
From: Matthew Deming <mddeming44@xxxxxxxxx>
To: Tesla Coil Mailing List <tesla@xxxxxxxxxx>
Sent: Fri, Nov 30, 2018 9:16 pm
Subject: Re: [TCML] GF NST,s

I think that I have figured out why your GF NST is working. With a standard
SGTC the start of the discharge looks like a dead short across the NST
secondary. (Pop!) The resistors dissipate enough power to keep it from
looking like a short to the NST. The only drawback is the power eaten by
the resistors is not available to the TC.

On Fri, Nov 30, 2018, 11:39 AM Douglas Johnson <doug379306@xxxxxxxxx> wrote:

> Hi Ed. Standard TC setup, except the {1K 25 Watt power resisters} are
> connected between the NST HV leads and safety gap lugs on the coil.
> Please understand, I have little technical knowledge here I was just
> playing around and it worked! I would hope some of the more technical
> minded members on the list would do a little trial and error with this, it
> could possibly open a new source of usable NST's, ie [GF NST's] for small
> and moderate coils.
> These power resisters are inexpensive as are aluminum heat-sinks if needed.
> I wish I had a 12 or 15K GF NST to test out but I do not.
> Thanks for your reply.
> Doug
>
> On Fri, Nov 30, 2018 at 9:05 AM Ed <evp@xxxxxxxxxxx> wrote:
>
> > What's your circuit?
> >
> > Ed
> >
> >
> > On 11/29/2018 6:53 PM, Douglas Johnson wrote:
> > > Gary, I am far from technical when it comes to this stuff as I am sure
> > you
> > > can see by a lot of my questions! It was just a fluke that I tried this
> > out
> > > of boredom. All I know is that it works. Take the resisters out, and GF
> > > pops.
> > > The resisters are similar in appearance to these >
> > >
> >
> https://www.ebay.com/itm/2Pcs-Wirewound-Ceramic-Cement-Resistor-0-5-1K-Ohm-5-25W-Watt/352350026175?hash=item5209b2b9bf:m:mowqAUe59odwZoiyCa7jxDg:rk:38:pf:0
> > > Maybe it works because, in my ignorance, I didn't know it wouldn't😉
> > > Doug
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxxxxxx
https://www.pupman.com/mailman/listinfo/tesla