Hello Jan,
Very nice web page. Too bad that you can't take a jack hammer to that roof to make it taller! Ha ha.
I have a question about your horn gap. I have a horn gap on my 6.5 KVA pig-powered coil but I have always wondered what the correct gap spacing should be. I initially set it using the 3 KV/mm rule of thumb but I found that it was firing too often so I set it a little wider. The coil has been running successfully with this setting for about 6 hours of run time so far. I always thought that the small diameter (about 3 mm) of my brass safety gap rods was was causing it to fire prematurely since I think that the 3 KV/mm rule is for flat plates and not small-diameter rods. What gap spacing do you use?
Steve White
Cedar Rapids, Iowa
----- Original Message -----
From: jan@xxxxxxxx
To: tesla@xxxxxxxxxx
Sent: Sunday, April 28, 2019 10:10:25 AM
Subject: [TCML] new website
Hi,
I have just put up a website for my coil:
www.sthlmteslacoil.se <http://www.sthlmteslacoil.se>
Please take a look and feel free to comment or critizise.
Jan
Stockholm, Sweden
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxxxxxx
https://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxxxxxx
https://www.pupman.com/mailman/listinfo/tesla