[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Attaching HDPE
Buy a cheap drill&tap set, cost you $10 and you'll get tons of use out
drill and tap the bottom of the supports for 1/4"x20 screws.
Put corresponding 1/4" holes in the top deck.
run 1/4" nylon screws up through the deck into the supports. Watch
out because nylon screwheads strip easily.
that's how i did it on my 12/60 coil.
______________________________ Reply Separator
Subject: Attaching HDPE
Author: "Tesla list" <tesla-at-pupman-dot-com> at INTERNET
Date: 8/7/00 5:44 PM
Original poster: "Ted Rosenberg" <Ted.Rosenberg-at-radioshack-dot-com>
I am about to construct my primary.
Many see to use HDPE for the supports and I would agree.
However, let's say you have a 1/2 inch thick by 2 inch tall strip (times 6
how do you attach that strip to your wood primary platform?
Metal screws from beneath?
Epoxy? (does it stick?)
Open to suggestions all (y'all)