[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Does my toroid look ok??



Original poster: "Mark Broker by way of Terry Fritz <teslalist-at-qwest-dot-net>" <mbroker-at-thegeekgroup-dot-org>

Looks good to me!  The typical dryer-ducting toroids are far rougher in 
appearance, and probably more fragile, than yours.

Mark Broker
Chief Engineer, The Geek Group

On Wed, 12 Mar 2003 19:38:02 -0700, Tesla list <tesla-at-pupman-dot-com> wrote:

>Original poster: "Jeremy D. Gassmann by way of Terry Fritz 
><teslalist-at-qwest-dot-net>" <gassmajd-at-email.uc.edu>
>
>I did a re-post, but I don't think it went through.  On my last email, I 
>must have been stupid at the time and forgot to put the link to my 
>website, so here it is:
>http://jeremyee.tripod-dot-com/jeremyeewebsite/id13.html  Sorry for missing 
>that!  Thanks again!
>
>Jeremy Gassmann
>At 06:53 PM 3/11/2003 -0700, you wrote:
>>Original poster: "Jeremy D. Gassmann by way of Terry Fritz 
>><teslalist-at-qwest-dot-net>" <gassmajd-at-email.uc.edu>
>>
>>Hi group!
>>I just finished a major part of my toroid, which was made from 4.5" black 
>>drain piping, 2" clear packaging tape and 2" aluminum tape.  To me it 
>>seems that the surface is not nice and smooth and was afraid that this 
>>might lead to high corona losses.  Below is the link to my toroid 
>>pictures on my web site (feel free to browse my entire site and I welcome 
>>any suggestions).  If it is possible, maybe someone can tell me if my 
>>toroid looks too rough based on the pictures that I have taken and can 
>>help me remedy this problem if it exists.  Thanks in advance!
>>
>>Jeremy Gassmann
>
>
>