[Home][2020 Index] Re: [TCML] DC motor fuse/rectifier issue [Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [TCML] DC motor fuse/rectifier issue



I would suggest a network near the diodes with around 60 dB attenuation above 50 kHz or so, pick a point well below the operating frequency of the coil

Regards
Bill

________________________________
From: Tesla <tesla-bounces@xxxxxxxxxx> on behalf of Ralph Hartwell <sparks@xxxxxxxxxxxxxx>
Sent: Monday, July 27, 2020 12:05:08 PM
To: 'Tesla Coil Mailing List' <tesla@xxxxxxxxxx>
Subject: Re: [TCML] DC motor fuse/rectifier issue

> grounded braided copper. I have an ammeter to monitor the motor, which
> indicates proper draw during runs (2-3 amps depending on speed), yet the
> cheap bridge (50 amp/1000 v) gets warm fast, and also does not endure an
> extended run on the coil.

The first question is - what happens when you run just the motor without firing the coil?  Does the rectifier overheat?

If it does not, then you likely have some RF from the coil getting into the rectifier circuit and causing problems.

If the heating still happens when the coil is not firing, then try a different bridge rectifier.  Looking at the circuit with an oscilloscope will tell you what's happening.
-

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxxxxxx
https://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxxxxxx
https://www.pupman.com/mailman/listinfo/tesla