[Home][2018 Index] Re: [TCML] Best Spark Gap for NSTs? [Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [TCML] Best Spark Gap for NSTs?



Sounds like you need to remove a bit more material "IF" you started off with a large enough motor. 

> On Feb 24, 2018, at 9:26 PM, Daniel Kunkel <dankunkel@xxxxxxxxx> wrote:
> 
> I modified a 1725 rpm motor to run in salient pole operation years ago. It
> will seek and then lock into phase and then break out again. I think I
> recall reading that if you don't remove enough rotor material it will seek.
> If you remove too much it will over heat.
> 
> So before to I take this back to machining, is it even worth it? What is
> the best gap for NSTs? Is SRSG is the answer what is the preferred break
> rate?
> 
> ~Dan
> To synch or not to synch
> Kansas City area
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxxxxxxxxxx
> https://www.pupman.com/mailman/listinfo/tesla

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxxxxxx
https://www.pupman.com/mailman/listinfo/tesla